ALERT: One of America’s Most POPULAR Gun Dealers Just Issued MASSIVE Recall – Check Your Guns IMMEDIATELY!

This is a health hazard situation where there is a reasonable probability that the use of this product can cause serious, adverse health consequences.

Ruger, one of America’s most popular gun manufacturers, has recently discovered that all Mark IV pistols (including 22/45 models) manufactured prior to June 1, 2017 have the potential to discharge unintentionally if the safety is not properly engaged.

If the trigger is pulled, while the safety lever is in between “safety,” and “fire,” the gun may not fire properly. If the safety is then fully engaged into the “fire,” option, it may or may not discharge.

Although there haven’t been any reported injuries, Ruger is offering to retrofit all “potentially defective,” pistols with an updated safety mechanism…at no charge to you.

Ruger lays out instructions, specifying how you can determine whether or not your pistol needs the retrofit:

“All Mark IV™ pistols produced prior to June 1, 2017 are potentially affected and therefore are being recalled. This includes Mark IV™ Target, Hunter, Competition, 22/45™, 22/45™ Lite and 22/45™ Tactical models.”

“These models bear serial numbers beginning with “401” (2017 models) or “WBR” (2016 models).”

In short, if your gun’s serial number begins with 401 or WBR, it needs to be retrofitted for your own safety. You can locate the serial number by checking on the location specified below.

gun recall alert

Ruger spokesperson Mark Gerny specifies that Mark I, Mark II, and Mark III pistols are not affected by this recall. In addition to this, some newly manufactured Mark IV pistols are also not subject to this defect.

Newly manufactured Mark IV™ pistols will begin with serial number “500.” Thus, if you have a Mark IV™ or 22/45™ pistol with a serial number beginning with the number “5,” your pistol is not subject to the recall.”

“Mark IV™ and 22/45™ pistols retrofitted with the updated safety mechanism are easily identified by the letter “S” in the white safety dot that is visible when the safety is engaged.”

gun recall alert

According to Ruger’s FAQ section, if you have to send the pistol back to be retrofitted, you do not need to send the entire pistol.

“We only want the grip frame assembly. It is not necessary for us to have the barrel/receiver assembly to perform the retrofit. Because the barrel/receiver assembly is the serialized component, not requiring its return simplifies the process and will enable us to more conveniently and quickly return the grip frame assembly to you.”

“Please follow the instructions in your instruction manual to separate the barrel/receiver assembly from the grip frame assembly. Keep the barrel/receiver assembly, magazines, lock, instruction manual, and any aftermarket accessories.”

“When we send you the box and shipping label, we will also send detailed instructions describing what we want you to send and how to send it.”

In addition to this, you must also remove any and all aftermarket accessories before returning the grip frame assembly to them. Ruger highly recommends that, if your gun is one of the defects, you do not shoot it until they retrofit it.

They urge you to contact them immediately. You can enter your Mark IV serial number in the link here to see if it is defective or not, and to discover if you’re eligible for a free retrofitting.